Step 4 - Motor Assembly

Parts Required for Step 4

Name

Part #

Qty

Image

NeveRest Classic 40

am-4609b

2

 ../../../_images/neverest-classic.png

Motor Mount Plate

76140

2

 ../../../_images/motor-mount-plate.png

30 Tooth Bevel Gear

76219

4

 ../../../_images/30-tooth-bevel.png

M3 x 10mm SHCS

76201

12

 ../../../_images/m3-10-shcs.png

Instructions

  • Pre-Load the 4mm setscrews into the 30 Tooth Bevel Gear. Be careful not to tighten the setscrews all the way

  • Slide the NeveRest Classic into the Motor Mount plate.

  • Using M3 x 10mm SHCS, screw the NeveRest Classic into the Motor Mount Plate.

  • Slide the 30 Tooth Bevel gear onto the NeveRest Classic Motor shaft. The set screws should face away from the motor, as shown below. Do Not fully tighten the setscrews.

  • Repeat these steps for the other NeveRest Classic Motor.

../../../_images/CampBotV2_View6.png